Our set makes both a horizontal and a perfectly matching, strong 45 degree joint by cutting 22-1/2 degree miters. Popular on cabinet corners or for making interlocking edge-to-edge joints on 8-sided projects such as planters. Use in router table only. Both bits two flute, carbide tipped, anti-kickback design. Sold as set only

brand - click here
What's the difference?

(1 Customer Review)    Write your own review

---

Product Rating:     Date Posted: 2009-09-06 12:08:33

horrible bits

Posted By: Kerry Barney Jr

Location: Cheyenne, WY United States

Comments: These have to be the worst bits I have ever used. They don't cut they tear. Even on pine they cut rough. On hardwood they rip the wood apart. Don't waste your money. you will only destroy your project.

Router Saftey Chart - Suggested Speeds:

Bit Diameter	Max Speed
up to 1"	24000 RPM
1-1/16" to 2"	18000 RPM
2-1/16" to 2-1/2"	16000 RPM
2-9/16" to 3"	14500 RPM
over 3"	12000 RPM

Router Saftey Tips:

• Always wear eye and ear protection.
• Always use properly sharpened bits.
• Never use bits that are dull or damaged.
• Shank must be completely inserted into collet and then backed-off approximately 1/16".
• Don't "bottom-out" bit in collet.
• Never partially insert bit into collet. Tighten securely and recheck periodically for possible slippage or "run-out" due to wear.
• Keep collet clean and replace if worn.
• Never start the router with the bit in contact with wood.
• Always feed your work in the proper direction against the bit rotation.
• Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
• Do not face tool's discharge when operating.
• Always unplug router when changing bits or making adjustments.
• Use a router table and fence whenever possible.
• Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
• Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
• The bigger the bit, the lower RPM recommended (see chart).