All bits ground to razor sharp points. Use for routing wheat patterns, drawer fronts, decorative panel veining, and edge chamfering. Use these bits to add a decorative accent to any furniture piece. The 22°, 45°, and 60° V-groove bits cut a very delicate vein and are used for sign making and wood threading applications. Also available with bearing for template routing. All bits two flute, carbide tipped. USA
- Part numbers ending with B feature top mounted bearings
- #132-0602B and #132-0622B are supplied without collars
- #132-0422 is single flute
- #132-0402, 0412, 0422, 0432 are solid carbide
- #132-2405, 2805, 4005 are great for making furniture joints on stock up to 1-1/4" thick.
6 Piece Sign-Making Bit Set #100-3212 Includes:
- 1/4" and 3/8" 90° V-groove
- 1/2" 60° V-groove
- 1/4", 3/8", 1/2" Round Nose bits.
- All Bits 1/4" shank
brand - click here
What's the difference?
Router Safety Chart - Suggested Speeds:
up to 1"
1-1/16" to 2"
2-1/16" to 2-1/2"
2-9/16" to 3"
Router Safety Tips:
- Always wear eye and ear protection.
- Always use properly sharpened bits.
- Never use bits that are dull or damaged.
- Shank must be completely inserted into collet and then backed-off approximately 1/16".
- Don't "bottom-out" bit in collet.
- Never partially insert bit into collet. Tighten securely and recheck periodically for possible slippage or "run-out" due to wear.
- Keep collet clean and replace if worn.
- Never start the router with the bit in contact with wood.
- Always feed your work in the proper direction against the bit rotation.
- Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
- Do not face tool's discharge when operating.
- Always unplug router when changing bits or making adjustments.
- Use a router table and fence whenever possible.
- Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
- Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
- The bigger the bit, the lower RPM recommended (see chart).