You'll find many uses for these bits. Make creative and decorative glue joints for drawers and jewelry boxes, Shaker furniture and shadow boxes, sliding dovetail joints for table and leg extensions, or sliding drawer and shelf runners and dividers. Smaller degree bits can be used for stair tread stringer mortising or shelf supports. Larger diameter bits will produce unique finger pulls. All bits two flute, carbide tipped. SAVE!
See our money saving sets, click here.Helpful Hint:
For best results when cutting dovetails and to minimize chipping and tearout, first cut the area with a straight bit to renove most waste. then cut with dovetail bit.NOTE:
•Item numbers ending with B
feature top mounted bearing
•P13-2239 is for Sears Dovetail Jig
•P13-2250 and P13-2258 are for Porter Cable Jig 4212
•P13-2238 is used for makeing Stair Treads brand - click here What's the difference?
Router Saftey Chart - Suggested Speeds:
up to 1"
1-1/16" to 2"
2-1/16" to 2-1/2"
2-9/16" to 3"
Router Saftey Tips:
- Always wear eye and ear protection.
- Always use properly sharpened bits.
- Never use bits that are dull or damaged.
- Shank must be completely inserted into collet and then backed-off approximately 1/16".
- Don't "bottom-out" bit in collet.
- Never partially insert bit into collet. Tighten securely and recheck periodically for possible slippage or "run-out" due to wear.
- Keep collet clean and replace if worn.
- Never start the router with the bit in contact with wood.
- Always feed your work in the proper direction against the bit rotation.
- Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
- Do not face tool's discharge when operating.
- Always unplug router when changing bits or making adjustments.
- Use a router table and fence whenever possible.
- Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
- Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
- The bigger the bit, the lower RPM recommended (see chart).