Slot Cutter 15/64" (5.9mm) 3 Wing by EAGLE

Economical, Interchangeable & Replaceable
SKU # 146-2330
$
In Stock

Shop with Confidence. Our GUARANTEE.

You'll find many uses for our slot cutters: mill rabbets, dados, lap joints, tongue and groove, biscuit and spline joints, T-molding installations and more. Use them to slot drawer sides for drawer bottom or make glass slots for picture frames.

All slot cutters are 1-7/8" in diameter with a 5/16" diameter bore. Cutters are interchangeable and can be combined and stacked on the same arbor giving you a wide variety of cutting possibilities. Make sure cutters are put on the arbor in the proper cutting direction and always use the supplied spacers between the cutters and bearings.

All cutters are three wing, carbide tipped. Cutters and arbor assemblies sold separately. USA.

Important Specs

  • Cutting Depth: 5.9MM (15/64")
  • Type: 3-Wing

Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).
Sign up for our Eclub!