Vertical Panel Raiser - Ogee Bead by EAGLE

For Use With 5/8" to 3/4" Material. Makes Great Drawer Fronts!
SKU # 186-4745
In Stock

Shop with Confidence. Our GUARANTEE.

The vertical panel raiser is designed for straight and square panels only. This bit can also be used to make attractive drawer fronts, table tops, plaques and moldings. By raising or lowering the bit in your router you can adjust the profile from 1" to 1-1/2" of reveal for 5/8" to 3/4" stock. Vertical panel raisers require the use of a router table with a support fence.

A minimum 2 H.P. variable speed router is recommended. Multiple light passes are required. Overall length = 3". Diameter = 1".


Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).
Sign up for our eNewsletter