Solid Carbide Spiral Downcut Bit 3 Piece Set

Clean and Accurate Cut with Minimal Chatter
SKU # 202
$102.85 $
SAVE $15!
In Stock

Shop with Confidence. Our GUARANTEE.

All three bits are SOLID MICRO-GRAIN CARBIDE for fast, smooth cuts and an edge that stays sharp longer. Spiral Bits produce a very clean and accurate cut with minimal chatter.

Solid Carbide Spiral Downcut 3 Piece Set: SAVE $15

Combo Package #202 Includes:

  • 1/4" dia, 1" Cut Length, 1/4" shank #5145
  • 3/8" dia, 1-1/4" Cut Length, 1/2" shank #7487
  • 1/2" dia, 1-1/2" Cut Length, 1/2" shank #7488

Product Instructions:

Solid Carbide Spiral Downcut Bit 3 Piece Set

Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).
Sign up for our eNewsletter