Vertical Raised Panel Router Bit Set by MLCS

Raise Panels Quickly and Easily
SKU # 8350
$119.80 $
SAVE $19.85!

Shop with Confidence. Our GUARANTEE.

These Carbide Tipped bits are designed to give you a full 1-1/4" reveal or larger (see carbide height sizes in chart) on your panels with a bit that measures only 1-1/8"(1-1/4" for #8680) in diameter! The vertical raised panel bits will allow you to raise panels quickly and easily. Use on 3/4" thick stock.

Includes the following 1/2" shank bits in a wood box:

  • #8680: 18° Straight (1-1/2" Carbide Ht.)
  • #8681: Cove (1-5/8" Carbide Ht.)
  • #8682: Ogee (1-1/2" Carbide Ht.)
  • #8683: Ogee & Bead (1-1/2" Carbide Ht.)

Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).
Sign up for our eNewsletter