Molding Bit 1-3/8" by MLCS
Create old world shapes with new world technology!
Recreate English and Colonial period furniture and trim. Add that early American touch to your home when making cabinet frames, raised panel doors, counter tops, crown molds and trim. Ideal accents for bookcases, small furniture pieces, table tip undersides, interior trim and even large picture frames. All bits are reversible and can be used in either direction for making either crown moldings or baseboards. All bits are 1/2" shank, two flute, cabide tipped, with bearing guides and feature anti-kickback design.
- C Cutting Depth: 1/4"
- D Large Diameter: 1"
- L Cutting Length: 1-3/8"
- Overall Length: 3-1/2"
- Shank Size: 1/2"
Router Safety Chart - Suggested Speeds:
|Bit Diameter||Max Speed|
|up to 1"||24000 RPM|
|1-1/16" to 2"||18000 RPM|
|2-1/16" to 2-1/2"||16000 RPM|
|2-9/16" to 3"||14500 RPM|
|over 3"||12000 RPM|
Router Safety Tips:
- Always wear eye and ear protection.
- Always use properly sharpened bits.
- Never use bits that are dull or damaged.
- Shank must be completely inserted into collet and then backed-off approximately 1/16".
- Don't "bottom-out" bit in collet.
- Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
- Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
- Keep collet clean and replace if worn.
- Never start the router with the bit in contact with wood.
- Always feed your work or router in the proper direction against the bit rotation.
- Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
- Do not face tool's discharge when operating.
- Always unplug router when changing bits or making adjustments.
- Use a router table and fence whenever possible.
- Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
- Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
- The bigger the bit, the lower RPM recommended (see chart).