Free "Best Way" Shipping Every Day in the Contiguous USA!( Shipping Info)

Crown Mold 2-1/2" - 1/2" Sh by MLCS

SKU #P14-3582
In Stock

Shop with Confidence. Our GUARANTEE.

Give your ceilings and case work cabinetry a finished look. Great for grandfather clocks. Use a 2 HP or greater table-mounted router. Using a 3/4" or greater by 2" board, make multiple passes, adjusting fence until profile is achieved. Cut off 45° excess using chamfer bit or table saw. Two flute and carbide tipped. Anti-kickback design.

NOTE: Router table use only!

Important Specs

  • D Large Dia.: 1-11/64"
  • L Cutting Length: 2-1/4"
  • Overall Length: 4"
  • Shank Size: 1/2"

Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).
Sign up for our eNewsletter