Wainscoting / Pedestal Router Bit by MLCS

SKU #7890 (Old/Eagle P14-3600)
$
In Stock

Shop with Confidence. Our GUARANTEE.

A multi-purpose carbide tipped router bit with totally enclosed ball bearing guide.

  • Puts a decorative edge on a pedestal base for collectibles.
  • Make the perfect base profile for your clock, curio cabinet, or window sills.
  • Great for the top edge of bookcases or cabinets.
  • Create an attractive cap rail to transition from wainscoting to upper wall.

Use stock at least 1" thick for the full profile.

Important Specs

  • (R) Radius: 1/4"
  • (D) Large Diameter: 2"
  • (L) Carbide Height: 1-1/16"
  • Overall Length: 3"
  • Shank Size: 1/2"

Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).

You May Also Like

Sign up for our eNewsletter