Panel Raiser-Large-2-Wing Wavy 1/2" Shk by PRICECUTTER

SKU # P15-3929
$79.99 $
SAVE 50%
In Stock

Shop with Confidence. Our GUARANTEE.

2Wing Horizontal - Bit features anti-kickback design and ball bearing guide. Use for cabinet doors or for raised panel effect on drawer fronts. Designed to cut 5/8" to 3/4" material. Minimum 2 H.P. variable speed router recommended. Do not exceed 12,000 RPM. Multiple light passes suggested. Use in router table only. Overall length 2-3/4".

Important Specs

  • Profile: Wavy
  • Type: 2-Wing Horizontal

Product Instructions:

Panel Raiser-Large-2-Wing Wavy 1/2" Shk

Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).
Sign up for our Eclub!