TripleWing Raised Panel Router Bits by MLCS
Raised Panel Bits produce a beautiful profile on your doors.
The Undercutter Panel bit lets you produce flush panels, adds a radius to the back sides of panels for decorative appearance or reduces the exposed upper panel profile. Cuts the back and front of the panel with one bit, featuring our TripleWing™ smooth cutting, long lasting three wing technology.
All Bits 1/2" Shank
Router Safety Chart - Suggested Speeds:
|Bit Diameter||Max Speed|
|up to 1"||24000 RPM|
|1-1/16" to 2"||18000 RPM|
|2-1/16" to 2-1/2"||16000 RPM|
|2-9/16" to 3"||14500 RPM|
|over 3"||12000 RPM|
Router Safety Tips:
- Always wear eye and ear protection.
- Always use properly sharpened bits.
- Never use bits that are dull or damaged.
- Shank must be completely inserted into collet and then backed-off approximately 1/16".
- Don't "bottom-out" bit in collet.
- Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
- Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
- Keep collet clean and replace if worn.
- Never start the router with the bit in contact with wood.
- Always feed your work or router in the proper direction against the bit rotation.
- Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
- Do not face tool's discharge when operating.
- Always unplug router when changing bits or making adjustments.
- Use a router table and fence whenever possible.
- Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
- Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
- The bigger the bit, the lower RPM recommended (see chart).
- Extra cutting blade (THREE flute versus 2-flute) saves time by allowing more aggressive cuts, and therefore, fewer passes.
- Run at reduced speeds, helping to eliminate burning on problem woods, such as, cherry, oak, and others.
- Produce 50% more cuts per inch, for a smoother, cleaner result
- Stay sharp and last 50% longer than standard 2 flute router bits