Miller Stepped Rabbet Bits by EAGLE
A framer's dream come true!
Tired of trying to figure out how to put a double rabbet on the back of a mirror or large frame? Here's your answer. Our new stepped rabbet bits put both a 3/8" x 1/8" or 1/4" ledge for glass or mirror plus an additional 3/8" by up to 1-1/32" ledge for the backing masonite or wood panel in just one pass! Two flute, carbide tipped, 1/2" shanks with 3/8" ball bearing guides. USA
brand - click here
What's the difference?

What's the difference?
Router Safety Chart - Suggested Speeds:
Bit Diameter | Max Speed |
---|---|
up to 1" | 24000 RPM |
1-1/16" to 2" | 18000 RPM |
2-1/16" to 2-1/2" | 16000 RPM |
2-9/16" to 3" | 14500 RPM |
over 3" | 12000 RPM |
Router Safety Tips:
- Always wear eye and ear protection.
- Always use properly sharpened bits.
- Never use bits that are dull or damaged.
- Shank must be completely inserted into collet and then backed-off approximately 1/16".
- Don't "bottom-out" bit in collet.
- Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
- Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
- Keep collet clean and replace if worn.
- Never start the router with the bit in contact with wood.
- Always feed your work or router in the proper direction against the bit rotation.
- Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
- Do not face tool's discharge when operating.
- Always unplug router when changing bits or making adjustments.
- Use a router table and fence whenever possible.
- Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
- Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
- The bigger the bit, the lower RPM recommended (see chart).
Product Options
You May Also Like
-
$39.99$29.99