Chair Making Bits by EAGLE
These uniquely tapered rabbet bits are used to join the arms and legs to the bottoms of elegant rocking chairs and stools. These bits were specially designed to allow you to make the "dovetail" joints.
All bits two flute, carbide tipped with bearing guides, 1/2" shank. USA
3 Piece Chair Making Bit Set
Combo Package #199-5175 Includes:
- +5 Degree Chair Making Bit #150-1705
- -5 Degree Chair Making Bit #150-1715
- 0 Degree Chair Making Bit #150-1725
Product Instructions:
Router Safety Chart - Suggested Speeds:
Bit Diameter | Max Speed |
---|---|
up to 1" | 24000 RPM |
1-1/16" to 2" | 18000 RPM |
2-1/16" to 2-1/2" | 16000 RPM |
2-9/16" to 3" | 14500 RPM |
over 3" | 12000 RPM |
Router Safety Tips:
- Always wear eye and ear protection.
- Always use properly sharpened bits.
- Never use bits that are dull or damaged.
- Shank must be completely inserted into collet and then backed-off approximately 1/16".
- Don't "bottom-out" bit in collet.
- Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
- Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
- Keep collet clean and replace if worn.
- Never start the router with the bit in contact with wood.
- Always feed your work or router in the proper direction against the bit rotation.
- Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
- Do not face tool's discharge when operating.
- Always unplug router when changing bits or making adjustments.
- Use a router table and fence whenever possible.
- Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
- Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
- The bigger the bit, the lower RPM recommended (see chart).