2 Piece Tambour Door Bit Sets by EAGLE

Make beautiful roll top desks, bread boxes and more!
Review star icon Review star icon Review star icon Review star icon Review star icon 5 of 5 Stars (1 review)

See Options Below

Shop with Confidence. Our GUARANTEE.

The unique interlocking pattern keeps slats aligned and has been designed to be used in both single and double curve applications. The slats can be mounted over canvas or joined with cable wire kit (not included) to allow the beauty of both sides to be seen.

Bits are 1/2" shank, two flute, carbide tipped. USA

brand - click here
What's the difference?

Product Instructions:

2 Piece Tambour Door Bit Sets

Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).
Write a Review

1 review
Very Happy by ()
Review star icon Review star icon Review star icon Review star icon Review star icon 5 Stars
I purchased the Tambour bit set for a roll top desk type project. I was very satisfied with the quality of cut that I had. The wood used was Red Oak. Cutting just over (30) 28" long pieces, the bit edge was sharp as it was at the beginning. The only best thing I could have had better was if this set would have been a matched set. Other than that I was VERY HAPPY with the results.

Product Options

Description Item # Price    Qty
2-Piece Tambour Door Set For 3/8" Stock 180-8015 $99.95
2-Piece Tambour Door Set For 5/8" Stock 180-8005 $124.95
Sign up for our eNewsletter