Cove & Round Over Raised Panel Door Router Bit Sets by MLCS

Make classic doors with a Cove raised panel and Round Over frame!

See Options Below

SAVE Up to $38.95!

Shop with Confidence. Our GUARANTEE.

Full Description Below...

Make classic doors with a Cove raised panel and Round Over frame!

Use with 3/4" stock. Includes 1/2" shank carbide tipped router bits. The Cove Panel Bit puts a classic cove edge on your door. The Round Over Matched Rail and Stile Set makes a strong, precisely mated joint. The cove raised panel bit is available with or without undercutter.

Set Includes the following 1/2" Shank Bits:

  • Cove Raised Panel with Undercutter Router Bit #8697 (*in Undercutter Set #8348 Only) produces a flush or reduced upper panel profile, or adds a radius to the back of the panel. 3-1/8" large diameter.
  • Cove Raised Panel Router Bit #8688 (*in Standard Set #8349 Only) puts a classic "cove" edge on the floating panel in your door. 3-1/2" large diameter.
  • Round Over Matched Rail and Stile Router Bit Set (#8843) creates a precisely mated joint that forms an extremely strong "classic" frame for your door. Both router bits have a 1-5/8" large diameter.

Undercutter Set #8348 shown in image.

These Router Bits are intended for router table use only.

Product Instructions:

Cove & Round Over Raised Panel Door Router Bit Sets

Router Safety Chart - Suggested Speeds:

Bit Diameter Max Speed
up to 1" 24000 RPM
1-1/16" to 2" 18000 RPM
2-1/16" to 2-1/2" 16000 RPM
2-9/16" to 3" 14500 RPM
over 3" 12000 RPM

Router Safety Tips:

  • Always wear eye and ear protection.
  • Always use properly sharpened bits.
  • Never use bits that are dull or damaged.
  • Shank must be completely inserted into collet and then backed-off approximately 1/16".
  • Don't "bottom-out" bit in collet.
  • Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
  • Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
  • Keep collet clean and replace if worn.
  • Never start the router with the bit in contact with wood.
  • Always feed your work or router in the proper direction against the bit rotation.
  • Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
  • Do not face tool's discharge when operating.
  • Always unplug router when changing bits or making adjustments.
  • Use a router table and fence whenever possible.
  • Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
  • Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
  • The bigger the bit, the lower RPM recommended (see chart).

Product Options

Description Item # Price    Qty
Cove & Round Over Undercutter Raised Panel Door Set 8348 $84.95
SAVE $38.95!
Cove & Round Over Standard Raised Panel Door Set 8349 $74.95
SAVE $34.95!
Sign up for our eNewsletter