These versatile carbide-tipped router bits create a dramatic door frame without complicated joinery. Great for mirror and picture frames, crown moldings, chair rails and other trim. Combine with any raised panel router bit to create highly decorative raised panel doors that until now have only been available through high end cabinet shops. Use a 1/4" slot cutter to create the slot for the raised panel or a rabbeting bit to make glass panel doors, mirrors or picture frames. The stock is mitered at 45°, glued and biscuit joined to create a sturdy secure joint. These bits are designed to work with 2-13/16" wide stock and a recommended thickness of at least 3/4". For cup hinges, use 1" thick stock (minimum). 1/2" Shank. Use in a 1/2" table mounted router only.
Mitered Door and Drawer Frame Complete Kits
- Mitered Door Frame Bit (Select from 5 Profiles)
- Mitered Drawer Frame Bit
- 1/4" Slot Cutter Router Bit
- 1/8" Slot Cutter Router Bit for Biscuits
- 100 #H-9 Biscuits
Router Safety Chart - Suggested Speeds:
|Bit Diameter||Max Speed|
|up to 1"||24000 RPM|
|1-1/16" to 2"||18000 RPM|
|2-1/16" to 2-1/2"||16000 RPM|
|2-9/16" to 3"||14500 RPM|
|over 3"||12000 RPM|
Router Safety Tips:
- Always wear eye and ear protection.
- Always use properly sharpened bits.
- Never use bits that are dull or damaged.
- Shank must be completely inserted into collet and then backed-off approximately 1/16".
- Don't "bottom-out" bit in collet.
- Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
- Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
- Keep collet clean and replace if worn.
- Never start the router with the bit in contact with wood.
- Always feed your work or router in the proper direction against the bit rotation.
- Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
- Do not face tool's discharge when operating.
- Always unplug router when changing bits or making adjustments.
- Use a router table and fence whenever possible.
- Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
- Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
- The bigger the bit, the lower RPM recommended (see chart).