Edge Beading Router Bits by MLCS
Also known as Quirk Bead Bits
2 flute, carbide tipped router bits with totally enclosed ball bearing guides.
- Also known as "Quirk" bead router bits.
- Form a small radius on the corner of the workpiece.
- Rotate the work piece and make a complete corner bead in 2 passes.
TIP: Use to match an existing bead mold trim found in older homes.
Router Safety Chart - Suggested Speeds:
| Bit Diameter | Max Speed |
|---|---|
| up to 1" | 24000 RPM |
| 1-1/16" to 2" | 18000 RPM |
| 2-1/16" to 2-1/2" | 16000 RPM |
| 2-9/16" to 3" | 14500 RPM |
| over 3" | 12000 RPM |
Router Safety Tips:
- Always wear eye and ear protection.
- Always use properly sharpened bits.
- Never use bits that are dull or damaged.
- Shank must be completely inserted into collet and then backed-off approximately 1/16".
- Don't "bottom-out" bit in collet.
- Never partially insert bit into collet. Minimum 1" of shank needs to be in collet.
- Tighten bit securely and recheck periodically for possible slippage or "run-out" due to wear.
- Keep collet clean and replace if worn.
- Never start the router with the bit in contact with wood.
- Always feed your work or router in the proper direction against the bit rotation.
- Don't force feed the bit or overload your router, Feed at a constant moving speed to avoid burning the wood.
- Do not face tool's discharge when operating.
- Always unplug router when changing bits or making adjustments.
- Use a router table and fence whenever possible.
- Make sure your work piece is properly secured and use push blocks, sticks and featherboards whenever possible.
- Keep all your bits, bearings and assemblies clean, lubricated, and securely fastened. To avoid damage, store them properly in a pouch, box or tray.
- The bigger the bit, the lower RPM recommended (see chart).
