Edge Banding Router Bits Sets by MLCS

Hide the ply with an attractive edge!
Review star icon Review star icon Review star icon Review star icon Review star icon 3 of 5 Stars (1 review)

See Options Below

Shop with Confidence. Our GUARANTEE.

  • Add an attractive & durable hardwood edge to your cabinet doors and shelf edges.
  • For use with plywood panels, MDF panels or shelves from 1/2" to 1" thick
  • Two piece set creates a perfectly matching joint
  • The 60° bits feature a tongue & groove for a larger glue surface area and easier alignment of edge banding
  • The 90° bits also make a horizontal V-groove or double sided chamfer.

Matched 2 piece bit sets are two flute, carbide- tipped. Simply center the male cutter on the stock and make the cut. Next match up the female cutter with the center point of the first cut. Finish by gluing together the two pieces and flush trim the edges, if necessary.

Recommended for use in a table mounted router.

Write a Review

1 review
It works with effort by ()
Review star icon Review star icon Review star icon Review star icon Review star icon 3 Stars
I cut over 60 feet of edging over the weekend. Using the edging bit was easy in my router table, ripped the pieces on the table saw next to it, run it through the router and back to the saw. However, plywood was a pain. It tends to tear out the edges of the ply. If you don't go deep enough into the edge, it leaves a gap when you insert the banding. If you go too deep then it tears out both sides of the finish veneers. So with some playing I found a "good enough" position. Also make sure you make the banding thicker than the ply by 1/16 or more on each side, since plywood is not exactly the same thickness I found that it would be off center and then short on one side and over on the other. So be prepared to sand sand sand to get a smooth seamless edging on both sides. Using upper feather board is a must to keep everything tight to the table. Good luck and hope to use this again on another project.

Product Options

Image Style L
Cutting
Length
D
Large
Dia.
Shank
Size
Item # Price    Qty
Edge Banding Router Bit Set 90°  1/4 90° 1" 1-1/2" 1/4" 5432 $44.95
Edge Banding Router Bit Set 60° with Tongue and Groove 1/4 60° with Tongue & Groove 1" 1-7/16" 1/4" 5433 $44.95
Edge Banding Router Bit Set 90° 1/2 90° 1" 1-1/2" 1/2" 7732 $44.95
Edge Banding Router Bit Set 60° with Tongue and Groove 1/2 60° with Tongue & Groove 1" 1-7/16" 1/2" 7733 $44.95
×
Sign up for our Eclub!